• Laptop stand on cushion

    We make a very comfortable and practicalLaptop holder on a pillow. A great stand for those who hold it on their lap when working at a laptop. Thanks to the soft cushion, your feet will be comfortable and pleasant, and the laptop will stand on a flat hard surface. If you wish, you can put a small cooling pad for a laptop on this stand.

    Materials and tools:

    1. 6-8 mm thick plywood sheet
    2. plywood sheet 10-20 mm thick
    3. dense foam rubber 3-5 cm (thicker);
    4. varnish (stain, paint) and brush;
    5. thick fabric;
    6. saw;
    7. sandpaper;
    8. marker or ruler;
    9. construction stapler;
    10. glue gun;
    11. Paint for fabric, foam brush and cardboard for stencil (if you apply the pattern on the fabric).

    Step 1

    From a sheet of plywood with a thickness of 10-20 mm, we saw out the main worktop of the stand. The size (width and length) depends on the size of your laptop - we add about 3-5 cm on each side to the width and length of the laptop. In this case, for a MacBook Pro 43x35 cm. &Nbsp;

    Thoroughly sand the surface and the edges of the tabletop with emery paper. We put the stain on the countertop.

    Step 2

    You can skip this step.

    Cut a stencil out of cardboard with a paper knife. Using paint on the fabric and foam brush, apply a pattern on the fabric through a stencil. Leave it to dry the paint.

    In this master class, a repeating pattern was chosen, so first they dyed the fabric. If you choose a single or complex pattern, then first it is better to wrap a pillow with a cloth and then apply the pattern.

    Step 3

    Now we take a sheet of plywood with a thickness of 6-8 mm and saw off a rectangle, the width and length of which is approximately 5 cm less than the width and length of the main table top. Next, cut out a thick foam rubber rectangle of the same size as plywood 6-8 mm thick.

    Step 4

    We put on the table first a cloth, then foam rubber and a rectangle of 6-8 mm plywood on top. We wrap a pillow with a cloth and fasten the edges of the fabric with a construction stapler to plywood. All excess fabric is cut off.

    Step 5

    Put the tabletop on the table, put a pillow on top of it, align it at the edges and lightly draw a pencil. Remove the pillow.

    Using a hot melt glue gun, apply a sufficiently large amount of glue to the circled area of ​​the tabletop. Put the pillow on top and press down. Wait until the glue dries.

    A hot glue gun glues wood surfaces well enough, but if you are worried, you can additionally fasten the plywood with screws and hide the hats with a decorative putty.

    Allsoft laptop standis ready.


    Related news


    The laws of etiquette: 18 rules that you MUST know
    The test will tell you what picture you look like
    TOP 25 Bright Ceilings for Original Interior
    Publications of Anastasia Samokhina
    How to disassemble the Nokia X2
    The popularity of stretch ceilings in the modern world